3-D Model of Turbine rotor

I used Solid Edge v20 software to make this 3D model of the rotor.....

Design pattern for cutting of PVC pipe

This is the patternfor how to cut the PVC pipe to make six same blades for wind turbine rotor!!! click on the image to enlarge it:

if u need to make 4 blades follow the same instructions using some different required values!!!.... this is the most effective and economic way to make blades and there is no wastage of the PVC pipe at all

Here is the Lay out of my project

This is a flow chart symmetric diagram of my project.....  everything is in sequence!!!.....


1. Wind turbine:

The purpose of wind turbine is to gain the energy from the air and convert it into Electrical energy. This is done by spinning the shaft of the turbine to produce current.

2. Charge controller:

The heart of this project is the charge controller, which is so callend the manager... it regulates the current and supply this to the battries at low current and high voltage to charge them.

3. Batteries:

As most of u know what does a battery is used for... all the batteries are connected in parallel and thus is called Battery Bank.

4. Inverter:

The last part is the inverter whose application is simple that it just converts the 12 volts to 220 volts to rum home appliances.... if ur batteries are 100AH then u might get a backup of 4~5 hours of free electricity!